Date: 12/6/15
Time: 3:00 PM
Location: Bell 242
Attendees:
Today we 3D printed the crossbar of our component. We used the makerbot printer in Bell with True Blue ABS plastic filament. We had to scale down our part because it would not fit on the printer bed and would use too much material. After scaling it down, the entire printing process took approximately 2 hours. Pictures are shown below.
Time: 3:00 PM
Location: Bell 242
Attendees:
- Dan Chelius
- Dwight Robinson
Today we 3D printed the crossbar of our component. We used the makerbot printer in Bell with True Blue ABS plastic filament. We had to scale down our part because it would not fit on the printer bed and would use too much material. After scaling it down, the entire printing process took approximately 2 hours. Pictures are shown below.